I have an Anker Powercore that has enough output to charge the SD while playing, so just wondering what is the most efficient method to get the most out of both power sources for long haul flights.
Many wrong answers here. Most devices have what’s called a power path. When a device is powered via a cable and the battery is full, the device battery is bypassed and the electronics powered via the charging port directly.
There are always losses in both charging and discharging a battery. Discharging the power bank first and the SD battery second avoids the charging loss from the SD battery.
You should avoid keeping either battery at sub 20% state-of-charge for long periods, if possible.
Thanks for the in depth response! So if I understand correctly, it’s better for battery health to use the bank first then the steam deck.
However if for arguments sake I want to get the maximum amount of play time, would bank first then SD still be the right way to go? I’m asking as perhaps the steam deck uses more power when plugged in as it doesn’t believe it should be preserving charge?
Bank first, then SD is good for both max play time and battery health, as the charging of the SD battery results in both energy loss as heat and minute degradation of the battery.
Plus then you can recharge the bank, usually at much higher rate than the deck charge rate, and plug it back in before the deck dies with more than 100% of the deck’s capacity.
No difference either way. Most flights have electrical recepticals under the seats, so you should be able to plug into power regardless.
As to your original question, you’re going to get the same performance either way. I personally just play the SD on battery and then charge it back up with the battery bank and then play it again.
When the SD is discharged, it tries to charge from the external power source (it doesn’t know that it’s a battery and not a charger). Battery to battery charging is just losing energy to heat. So, it’s probably better to discharge the external pack while the SD is at 100%.
Also, you should never discharge a battery to 0, or do it regularly, as it will damage the battery and make it keep less charge.
Any good battery management system should avoid that.
Well actually no, the battery health is counted in charge circles, so if you charge from 0 to 100 it is one charge, if you charge from 50 to 100, then again from 50 to 100 it is again one charge.
Other than that when you use the battery and let daily to reach 0% it may be over discharged and start creating crystals damaging the battery, the battery would never actually be under 2-5%, but why stress that battery? I’m charging my devices at 20% and it helps with the battery life.
Also if you want long, healthy batteries you shouldn’t charge to 100 as not to overcharge but who does that?
Apples battery management stops charging at 80%, according to your behavior. If you use the laptop with power connected a lot, it will stop charging and resume later.
This is dependent on battery chemistry. True for common LI-ION.
