I’m in the exact same boat. I have a Jellyfin server configured and ready to go whenever something happens to really piss me off. This nearly was it until I saw that my lifetime Plex pass I bought 10 years ago will make it still be free for my family.

There are password managers you can self host. Bitwarden being one of them. Secure it as much as you want and keep off-site encrypted backups if you’re worried about a single point of failure.

It’s probably that. While on cellular my IP isn’t 192.0.0.4 (but it is in 10. space), but there’s probably some v6 somewhere in the way.

I can’t get it to have network connection while my phone is on cellular data. On wifi it’s fine.

I used mostly this, but had to customize it a bit I think to get things working right. NUT feels like a super finicky system, but in the end it does work. My biggest issue right now is that it only reports a new status update to Home Assistant every few minutes, so the actions don’t really get a chance to trigger before the server shuts down. It also shuts down with the UPS at way too high of a percentage remaining, so I need to figure out how to make it wait just a little bit longer before the power down. It wants to power off like < 2 minutes after the power goes out…

https://chribonn.medium.com/proxmox-nut-homelab-howto-step-5-install-nut-ups-solution-configure-nut-for-email-alerts-and-be74838fdccb

I’ve got a project to look forward to. Have my Proxmox server with a UPS, running NUT to watch the battery percentage and power down gracefully if the % gets too low. I have Home Assistant watching that so it’s supposed to notify me before that happens. It’s not notifying me though, so I gotta look into that. I know it’s not working this morning because the power went out, so now I’m just sitting here theorizing instead of actually looking at it. 🙃

How hard is replication across servers with just debian and qemu? I’m honestly not super great on linux knowledge. I’m a Windows sysadmin by trade, with maybe 10-20% linux. I run a few Ubuntu server VMs at home and some RHEL at work. So I’m looking for something as easy to set up and well-documented and supported as possible. Proxmox just seemed like the “industry standard” for selfhosting, but I was also looking at Unraid (which is supposedly better at storage and less good at virtualization) or even ESXI, but I didn’t want to get into the VMWare payment bubble if I needed anything more than a simple host.

Thanks, I wasn’t sure about the data being taken care of first or last. First makes a lot more sense though. And prepping as many services into VMs ahead of time definitely sounds like it’ll be the best way to reduce downtime, even if I then end up moving it into a different container again later on.

I hadn’t seen that. Thanks for the link! That’s definitely gonna be helpful.