Here are the parts that I used:

PCB: Lily58 pro MCU: Splinky rp2040 Switches: Akko v3 pro Lavender purple Keycaps: Tuzi in XDA profile

With custom built cables, and just a front and back plate that I got along with the PCB.

According to where I bought it from and here this specific MCU shares the footprint with a pro micro with extra gpio pins

I am a dev, so I just modified the different letters to suit myself. I will probably make changes to it later if/when I realise some other layout or key combination will be better.

Here are the parts that I used:

PCB: Lily58 pro
MCU: Splinky rp2040
Switches: Akko v3 pro Lavender purple
Keycaps: Tuzi in XDA profile

With custom built cables, and just a front and back plate that I got along with the PCB.

The keycaps are called Tuzi.

I learned to properly solder(I’m still not great at it, but by the end I started getting better). And basically everything to do with building a keyboard.

I’m definitely gonna be customising my layout, probably often until I figure out everything I need. And maybe also do some custom stuff on the oleds too. Right now it has bongo cat that plays the animation when the wpm goes high enough (taken from here)

The keyset is called Tuzi.

I’m using qmk and I didn’t see anywhere in the guides that I had to use different firmware for both halves. It told me to use the same on both.