I’m already half a dozen prints in and loving it 😁

Yeah I’m fine with copying prints via sd card, and that’s what I’m doing for the moment. A1 mini came very fast and I just did the tug boat classic first print

Groovy 😎

Awesome, thank you for the insight!

Awesome, thank you for the info, probably pulling the trigger today 😁

I’m looking at a Sunlu 4 pack of 1kg PLA, would that be fine filament to start with? I matched the diameter with what they sell on bambu lab.

Ugh I didn’t even think about that, the data collecting. After some research I think I should be able to mitigate that with lan only mode or just some firewall rules or pihole blocking. Thank you for the link!

I was looking at the sunlu s1 and s2 for a filament dryer. The s2 sounds kinda glitchy but functional, and the biggest complaint of the s1 seems to be the 55C max temp.

If my humidity is usually 20% or lower where I live is it likely I can just skip a filament dryer for now?

I’ve been using Firefoxs integrated password manager for lots of unimportant logins, KeePass for everything else.