What was it? Op deleted his comment

Yeah if it came to that I would, but I’d like a not elegant repair first.

Looks aren’t an issue, but I feel like I’d feel that lump of polish

Thanks for the recommendations!

Thanks!

Very cool looking, I will consider this thank you! I had no idea

I recently learned what that means from perusing this community haha

Holy cow thanks for all this extremely specific instruction! I will look into it and report back!

No worries thanks for the information!

That’s good to know thanks!

Good to know, I’ll have to play with it.

Ah that makes sense haha

Hmmm, that doesn’t sound very encouraging haha. Well I’m gonna try PEI anyway, see if I can keep it flat enough.

That’s encouraging!

I thought too cold caused warping, does too warm cause it as well?

Now I know this to be true

I put the whole apparatus in the fridge for a few hours, hoping it would just pop off.

The edges came up clean, but the very middle was very unhappy. I had some lifting on the corners so I think there was a draft and the plate wasn’t warming equally. Hot spot in the middle trying to keep up maybe? IDK.

This is a pretty deep hole, I don’t think tape will cut it.

But I’ve been printing little things on the front portion 🤷‍♂️

I do this too, normally it works a treat.

Somehow I missed all the warning signs and discussion on the subject. I’ll never forget.

Can’t be much worse than a big hunk of glass?