They don’t. There is no scheme. Nobody gets fired because they’re a DEI. People get fired because of blatant racism.

You also could make it the default search engine in the settings menu. Also works on desktop.

I just read a bit through some forum posts, and the 3 v2 seems to be one of the worst printers in Enders whole lineup. That’s probably why our experiences are so different.

I think calling Ender “Chinese Crap” a bit harsh. I’m using an Ender 5 Plus, and I love it. Didn’t even had to tinker a tiny bit to get it working right (Except for Leveling of course). It’s reliable as hell, and not even 2% of my prints fail. Only improvement I would recommend is a a smaller nozzle.

It’s a SSD, but I do not Pull the plug or hold the power button EVER on this machine. Stop thinking you know everything if you have no idea.

It’s an SSD but OK…

OK, just to clarify a few things, because a lot of people are being smartasses here in the comments:

1. It’s a relatively new (1-2 Months old) Samsung NVME drive.
2. I do NOT hold to power button or pull the plug on this machine EVER.
3. The drive is in prestine conditions. Not a single bad sector. Use the same drive DAILY on Linux and disk utility reports no bad sectors.

So stop talking nonsense if you don’t know what’s going on.

It’s actually on a SSD but ok… A NVME to be exact

I’m literally daily driving the same drive with Ubuntu 24.04. No problems there. This is an OS Problem.

You noticed the 1578%, right?

Who even uses Snap anyway? I either use apt (or .deb) or flatpak. Snap is just the worst of both worlds…

But why would they make their own Apps non-GTK (Gnome Software Store, Gnome Settings, System Monitor…)?

Exactly, but even the Official Gnome Settings don’t work with GTK anymore?! I just don’t get why…