• 3 Posts
  • 9 Comments
Joined 1 year ago
cake
Cake day: June 20th, 2023

help-circle







  • How about this then? (No promises on signal integrity of that USB signal, we are pushing limits)

    Just keep in mind, that placing the controller not at an edge, will likely make the USB port interfere with the next socket, it’s not really meant for that. Meaning you should probably de-solder the port then. Also, by powering through the 5V/GND pins, you negate the VBUS detection, and there simply aren’t enough pins/space to break that out as well, so it’s a compromise.



  • I wasn’t planning on it since sacrifices two pins.

    And seeing as the USB port is available to place by the edge very easily as you can place the controller over any key.

    To explain, the USB port should end up needing only 3-5 mm edge on a sandwich case, or a hollow similar to how most pcb’s place it on a CNC/3d case.

    Any particular reason beyond that? I’m open to reasonable compromises.

    Btw, I can easily pull them out to a pair of pads, there is space for that.