Title basically.

Obviously, cold nozzle + filament on it from my last print = the printer thinks the nozzle is lower than it actually is.

Preheating the nozzle helps some, but if I want true consistency I need to mechanically whipe the nozzle/grab the bit of plastic that oozes out with a pair of needle nose pliers.

I know nozzle brush mods are a thing, but aren’t the hard on your nozzle? Does anyone have any alternative ideas?

  • dirtdigger@lemmy.worldEnglish
    4·
    1 year ago

    If you have a hardened nozzle and brass brush, it shouldn’t be too abrasive. I’ve usually done that with my MK3S+ and never had issues.

    • IMALlama@lemmy.worldOPEnglish
      2·
      1 year ago

      Thanks for the information. I do have a hardened nozzle, glad to hear that a brass brush won’t abrade it over time.

      • Sierra4@lemmy.worldEnglish
        2·
        1 year ago

        I wouldn’t worry, brass is usually way softer than most metals and if you do completely crazy on it there shouldn’t be a problem.

        Brass is also used for bearing, so it wears out before e.g. the steel axle in it does.