This is a remix from https://www.thingiverse.com/thing:3495751 A re-design of Leecarl's Sim Racing Button Box, modified for use with American Truck Simulator / Euro Truck Simulator. I modified the face plate to utilize the switches/buttons I needed. I also included a blank faceplate template for others to start with. I had to remove the letters from the clamp bolt, clamp body, and main body as my printer was having troubles getting them to stick to the bed and not get dragged around into the rest of the print. Additionally, I had to lengthen the clamp so that it would fit on my desk. I have also included a modified back plate that utilizes a single USB Type B port intended for an Arduino to sit on the bottom of the box. For the knobs I used genuine Bendix MV-3 air brake knobs. I have included an .stl for an adapter to allow these 5/8" threaded knobs to be used with a smaller, electric push/pull switch. All credit for the original design belongs to LeecarL (https://www.thingiverse.com/leecarl/designs)

This is a remix from https://www.thingiverse.com/thing:3495751 A re-design of Leecarl’s Sim Racing Button Box, modified for use with American Truck Simulator / Euro Truck Simulator. I modified the face plate to utilize the switches/buttons I needed. I also included a blank faceplate template for others to start with. I had to remove the letters from the clamp bolt, clamp body, and main body as my printer was having troubles getting them to stick to the bed and not get dragged around into the rest of the print. Additionally, I had to lengthen the clamp so that it would fit on my desk. I have also included a modified back plate that utilizes a single USB Type B port intended for an Arduino to sit on the bottom of the box. For the knobs I used genuine Bendix MV-3 air brake knobs. I have included an .stl for an adapter to allow these 5/8" threaded knobs to be used with a smaller, electric push/pull switch. All credit for the original design belongs to LeecarL (https://www.thingiverse.com/leecarl/designs)