That’s a fair assessment, and based on the responses and some of my own research I think I’ll be going for a Prusa, maybe second hand.
The only reason I chose the delta was because the place I was working at the time had one for prototyping, and I was familiar with it so I thought I could get it to work well at home. I didn’t realize it would be “hard mode” until too late, haha.
Thanks for the advice. The model I got (SeeMeCNC RostockMax 3.2) has a stationary glass bed and this fancy system where it probes the bed and automatically makes a height map. I might end up trying to get a new bed surface like you suggested before springing for a whole new machine.
What’s wrong with Bambu?
Mostly little gadgets, mechanical things, or small figures or terrain pieces for wargaming, so I’d like a high level of detail (I’m fully aware that it won’t be nearly as good as a resin printer). I’d like to be able to print with PLA, ABS, ASA, and PETG, and envelope doesn’t need to be huge, probably about 10” at most.
I’d say no-hassle is more important, in that case. I just don’t want to go spending $1000 on a printer again
I’m partial to this one
Plants don’t have the ability to pull out a gun to defend itself
Yet.
How do you build a system that doesn’t depend on voters not being morons? Everything I can think of, up to and including full-on authoritarianism, has human shittiness as a glaring weak point. The founding fathers assumed that people would, for the most part, act in good faith, and it kept us going for a couple hundred years, but all that is starting to fall apart.